3D Print Timelapse: Bullseye Duct Re-Print

2

  • 56
  • 0
  • 6.984
  • Reply

  • Open in the desktop app ADD TO PLAYLIST

    l337m45732

    Published on Oct 18, 2021
    About :

    So I printed some upgrade for my Ender 3 Pro recently. One of those was a Bullseye duct.
    This allows for better airflow and it aims the air directly to the nozzle.

    I initially printed at 0.28mm Layer height because I didn't think quality would matter. It does.
    I also printed with 60% infill thinking it wouldn't need to be very sturdy since it's just an air duct. This was fuck up number 2.

    The print came out looking decent but the mout immediately broke off. Out came the superglue. About 7 different times.
    I was frustrated so I rigged it and have been using it for the past couple days.

    Time to reprint that bad boy. New settings:

    0.2mm layer height, 100% infill. 6 walls.

    Much better print, and much more sturdy. Me likes.

    Tags :

    3dprinting threedprinting print3d diy technology timelapse stem

    Woo! This creator can upvote comments using 3speak's stake today because they are a top performing creator! Leave a quality comment relating to their content and you could receive an upvote worth at least a dollar.

    Their limit for today is $0!
    Comments:
    Time until l337m45732 can give away $0 to their commenters.
    0 Days 0 Hours 0 Minutes 0 Seconds
    Reply:

    To comment on this video please connect a HIVE account to your profile: Connect HIVE Account

    00:06
    8 views 2 years ago $

    More Videos

    10:00
    3 views 2 years ago $
    03:25
    7 views 2 years ago $
    05:51
    4 views 3 months ago $
    08:13
    0 views 2 years ago $